TECO GROUP provides comprehensive electrical testing, thermal imaging, consultation, and maintenance services for industrial and commercial facilities across Jordan. As an authorized Siemens System Integrator, Schneider Electric Panel Builder, and RITTAL Panel Builder, we deliver reliable, standards-compliant services backed by professional-grade calibrated equipment.

Our services cover the full spectrum of electrical testing, inspection, and maintenance:

  • High voltage testing (AC and DC) for panels, cables, bus bars, and overhead lines up to 40 KV.
  • HV and LV cable fault location and insulation testing up to 33 KV networks.
  • Current injection and relay setting — primary injection up to 2,000A and secondary injection up to 100A.
  • MCC functional testing including logic verification, phase/neutral/earth protection, and wireless communication testing.
  • SCADA and automation testing for Siemens and Schneider Electric based control systems.
  • Generator set testing and commissioning up to 2,500 KVA / 11 KV, including synchronizing of multiple gen-sets.
  • Power transformer testing — ratio, impedance, and vector group verification up to 3,000 KVA.
  • Thermal imaging inspections using FLIR equipment for predictive maintenance of electrical panels, motors, cables, and connections.
  • Primary injection testing to verify circuit breaker trip units and end-to-end protection circuits.
  • Earth resistance testing and ground earthing point verification.
  • Motor set alignment using SKF laser alignment systems.
  • Fiber optic installation testing and verification.
  • Network and power supply analysis — KVA, KW, Volt, AMP, COS phi, Hz, and power quality measurement.
  • Load, consumer, and motor testing with comprehensive electrical parameter measurement.

We also provide expert consultation, operation, and maintenance services:

  • Electrical and automation consultation — system design review, SCADA/DCS architecture planning, switchgear specification, and technical audits.
  • Power distribution and energy efficiency analysis including power factor correction recommendations.
  • Operation and maintenance contracts — preventive and corrective maintenance for switchgear, SCADA systems, and industrial automation.
  • Emergency response, troubleshooting, and scheduled inspection programs for ongoing facility support.
  • Commissioning, training, and handover services for new installations.
  • Project feasibility studies and technical due diligence.

TECO GROUP has delivered testing and maintenance services across a wide range of sectors: